PC based Online Ceiling Fan Analyzer

D-9005 CFA

The PC Based Automatic Fan Analyzer is the most comprehensive tester designed to automatically check the quality of Ceiling Fans including the BLDC Fans mounted on the conveyors.

Download Brochure

FEATURES

• Infinite Model storage capability
• Job work management area for Test data reference
• 17 inch DELL monitor display with ADVANTECH Industrial PC
• LABVIEW software based Application to Test, Store and Print test reports.
• Permission based Login system
• Software defined limits for Test parameters
• Online line support and calibration using remote access software

TEST SPECIFICATIONS

The Automatic Online Ceiling fan Analyzer is installed directly on the conveyor and ceiling fans are tested by applying the voltage to the bus bars mounted on the conveyor.

I) H.V Flash Test (Bus Bar – I)

The H.V Flash test once again checks the strength of the ground wall insulation but at a higher applied voltage than the I.R test. If there is sudden surge in the leakage current it indicates that the ground wall insulation is weak and the test has failed.

H.V Flash test = (2×E + 1000) where E is the operating voltage

Test Voltage	0-2.5KV AC (Adjustable)
Test Time	0-10 sec
Overtrip Leakage Current Limit	0.1-10 mAmps

II) Low voltage Start Test (Bus Bar – II)

The Low voltage Start test is performed at low voltage of around 100V to check if the fan rotates at low voltage and there is no jammed rotor inside the fan. The readings of Wattage, Current and PF are measured and compared against the defined parameters set by the operator.

Test Voltage	0-270 Volts (Adjustable)
Wattage Limit	0-2000 Watts
Current Limit	0-8 Amps
Power Factor Limit	0.000-1.000
Test Time	0-10 sec

III) Full Voltage No Load Test (Bus Bar-III)

The Full Voltage No Load Test is performed at full run voltage of around 230 V to check the electrical parameters of the ceiling fan. The readings of Wattage, Current and PF are measured and compared against the defined parameters set by the operator. The operator can also set the applied test voltage.

Test Voltage	0-270 Volts (Adjustable)
Wattage Limit	0-2000 Watts
Current Limit	0-8 Amps
Power Factor Limit	0.000-1.000
Test Time	0-10 sec